Despite high feed costs, milk-feed ratio shows improvement

 Resize text         Printer-friendly version of this article Printer-friendly version of this article

After falling to its lowest level in history, the milk-feed ratio is slowing climbing back. 

On Thursday, the U.S. Department of Agriculture pegged the preliminary ratio for September at 1.46 ― up from 1.34 in July and 1.36 in August.

The improvement is due to higher milk prices.

The all-milk price used in USDA’s calculation rose from $18.10 per hundredweight in August to $19.10 per hundredweight in September.  

However, corn remains high at $7.35 per bushel (compared to $7.63 in August). Soybeans actually rose 10 cents per bushel from August to September, and alfalfa hay went up $2 per ton.

The milk-feed ratio is a rough measure of dairy profitability.

The milk-feed ratio represents the pounds of 16-percent mixed dairy feed equal in value to 1 pound of whole milk. Therefore, with a 1.46 ratio in September, a dairy producer could buy 1.46 pounds of feed for every 1 pound of milk sold.

Some people question how valid the USDA’s milk-feed ratio is. See this story. But the USDA has been using the same formula for years, comparing the same commodities. Therefore, it can serve as a relative measure for comparing different points in time.

The ratio is found in the USDA’s monthly “Agricultural Prices” report.



Comments (2) Leave a comment 

Name
e-Mail (required)
Location

Comment:

characters left

CD    
AZ  |  September, 28, 2012 at 08:23 AM

Improvement? Still below even a 1.50? Less than half what it should be to be profitable? How about a headline that reads "Milk-feed ratio continues to show dairy to be unprofitable." There is no optimism to be gained by a 1.46 ratio. Don't try to show it in the headline.

ginny    
pa  |  September, 28, 2012 at 10:18 AM

On the contrary, it is very easy to write about it when you're not the one actually writing out the checks to pay for that 'improved' ratio!


5E Series

Introduced in 2013, the new 85 and 100 hp John Deere 5085E and 5100E feature 4-cylinder Interim Tier 4 emissions-compliant ... Read More

View all Products in this segment

View All Buyers Guides

)
Feedback Form
Leads to Insight