10 Do’s & Don’ts for ‘Low-Cost’ and ‘Retrofit’ Milking Parlors

Farm Journal logo

Learn the do's and don't for retrofitting a parlor on a budget.
By: Dan McFarland, Agricultural Engineering, Penn State Extension

As tie stall dairy producers think about herd expansion they often consider converting their existing building into a milking center. In many cases this is a reasonable idea. However, ‘low-cost’ should not be interpreted as ‘cheap.’

Harvesting milk is one of the most important jobs on a dairy farm, so the milking area should be a comfortable, low stress area for both cows and those milking them. Quality milk comes from a quality place of work. Careful planning and attention to details that enhance performance and encourage a proper, consistent milking routine is essential.

Dr. Doug Reinemann, Professor, Biological Systems Engineering at the University of Wisconsin–Madison, suggests the following ten do’s and don’ts when planning a milking parlor—especially for ‘retrofit’ and ‘low-cost’ alternatives.

  1. Know How Much You Can Spend:
    A good financial analysis of the farm operation is step one. An unprofitable business cannot afford to invest anything. Saving time does not improve profitability unless there is more profitable use of that time. ‘Low-cost’ is sometimes defined as a total annual cost of milking, including labor and facilities, that is less than $1.00/cwt. To be competitive build a ‘reasonably’ sized parlor that fits the budget and avoids putting an extra person in the milking area. Adding more operators never increases the number of cows milked proportionally to the added labor cost.
  2. Let the Installer Design the Milking System:
    Designing the parlor and milking system to meet all the sanitary and safety regulations is a highly skilled task. Seek the advice of a competent milking equipment installer to work through the planning process with you.
  3. Don’t Over Estimate the Value of Old Equipment:
    Let your trusted milking equipment installer determine the value of used milking equipment. Most milking equipment is only supported for 10 to 20 years. Replacement parts for older equipment may be unavailable, hard to get, expensive, or all of the above. Maintenance on older equipment can be labor intensive.
  4. Get the Building Right:
    Buildings generally last a long time and are difficult to remodel. Equipment may last 10 years and is easy to upgrade, as long as the building isn’t the limiting factor. Always compare the cost of renovation versus a new building. It is not always less expensive to remodel, especially if structural modifications and significant concrete removal is necessary. Plan the milking center of your dreams, then scale back. If the budget is limited, spend it on a good building (with a future) and start with a ‘bare-bones’ milking machine.
  5. Plan the Building, Stalls, and Holding Area for Good Cow Flow:
    Lack of good cow movement into and out of the milking parlor is frustrating for both the operator and cows. The milking parlor should be designed to keep the stress level of both the cows and the milkers low. Eliminate turns whenever possible. Where turns are necessary provide adequate space and reduce the number of direction choices cows must make on their own.
  6. If You Remodel—Rewire:
    Almost every old barn lacks an electrical system that is adequate and safe. Wiring wears out and new wiring methods have been developed. Often the existing wiring cannot handle the capacity of the new electrical equipment added to the parlor.
  7. Put in Good Lights:
    Plenty of good quality light makes a good work environment. Install energy efficient lights with fixtures designed to operate in a damp location.
  8. Consider Energy Saving Technology:
    Energy efficiency is a good investment. There is often a 2- to 6-year payback on investments for variable speed drive vacuum pumps, well water pre-cooling of milk, and heat recovery from the refrigeration system.
  9. Make Sure Floors Drain Well:
    Beware of amateur concrete work! Wet floors make for a slippery, unpleasant work environment. Create mono-slope floors that drain to a gutter rather than multiple slopes to a single drain. Use a minimum slope of 0.25 inch per foot.
  10. Install Good Ventilation:
    Ventilation is essential to control the levels of moisture, gases, and pollutants. Cold weather systems provide enough air exchange to provide fresh air, remove moisture, and maintain a comfortable temperature. Warm weather systems do the same, but require a much more rapid air exchange. Be sure to provide adequate controls to allow the system to operate for a time after parlor wash down (and after the operator has left) to remove moisture.

‘Low-cost’ and ‘retrofit’ milking parlors do not need to be a ‘cheap’ compromise to a new milking facility. With honest, objective evaluation of the building, proper planning, and attention to detail a sanitary, productive, and safe environment can be created for both the cows and the people milking them.

 

Latest News

APHIS Now Thinks Wild Birds Are to Blame for Highly Pathogenic Avian Influenza's Arrival on Four U.S. Dairies
APHIS Now Thinks Wild Birds Are to Blame for Highly Pathogenic Avian Influenza's Arrival on Four U.S. Dairies

The livestock industry continues to grapple with the first confirmed cases of HPAI in cattle, while federal and state agencies continue to assure consumers there's no concern about the safety of the U.S. milk supply.

Success is All in the Details at Kansas Dairy Development
Success is All in the Details at Kansas Dairy Development

Kansas Dairy Development provides temporary housing for up to 80,000 head of cattle — from a few days old to springers nearly ready to calve. Their formula for success is all in the details.

Skills Survey Reveals U.S. Agriculture & Food Industry Workforce Needs and Gaps
Skills Survey Reveals U.S. Agriculture & Food Industry Workforce Needs and Gaps

U.S. employers report challenges in finding suitable job candidates with work-ready skills to fill open roles in ag. The AgCareers.com U.S. Skills Survey offers insights, data and trends to address skill development.

Built Out of Love: How Two Sisters Created a Super-Fast-Growing Yogurt Company
Built Out of Love: How Two Sisters Created a Super-Fast-Growing Yogurt Company

Travel to the rolling hills of Pennsylvania, and you’ll meet Hayley and Stephanie Painter who not only made the Forbes 30 under 30 list, but have also created one of the fastest growing yogurt company in the U.S.

"Boring" Technology Will Reshape Dairy Over the Next 10 Years
"Boring" Technology Will Reshape Dairy Over the Next 10 Years

Once a technology becomes a boring experience it means it has become proven, well-adopted, and easy to utilize. There are three "boring" technologies silently shaping the industry.

Influential Dairy Leaders Awarded World Dairy Expo Recognition Awards
Influential Dairy Leaders Awarded World Dairy Expo Recognition Awards

World Dairy Expo is delighted to announce the recipients of the 2024 Expo Recognition Awards. These individuals have made remarkable contributions to the dairy industry and their communities.